STEREO COMPONENT AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the stereo stereo component amplifier assembly removal /installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (for 2AR-FE)

Click here

Stop and start system (for 2GR-FKS)

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

PROCEDURE


  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  2. REMOVE CONSOLE BOX ASSEMBLY (for Integrated Console Box Type)

    Click here

  3. REMOVE CONSOLE BOX ASSEMBLY (for Separate Console Box Type)

    Click here

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  6. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  7. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  8. REMOVE FRONT FLOOR CARPET ASSEMBLY

    Click here

  9. REMOVE FRONT FLOOR SIDE PAD LH

    Click here

  10. REMOVE FRONT FLOOR SIDE PAD RH

    Click here

  11. REMOVE REAR NO. 5 AIR DUCT

    Click here

  12. REMOVE REAR NO. 3 AIR DUCT

    Click here

  13. REMOVE REAR NO. 4 AIR DUCT

    Click here

  14. REMOVE REAR NO. 2 AIR DUCT

    Click here

  15. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. B006NRD

      Disconnect the 5 connectors.

    2. B006N61

      Remove the 4 bolts and stereo component amplifier assembly with bracket.

    3. B006RKZ

      Disengage the clips to remove the audio amplifier cover.

  16. REMOVE PARKING ASSIST ECU

    Click here

  17. REMOVE NO. 1 AMPLIFIER BRACKET


    1. B006QKM

      Remove the 2 screws and No. 1 amplifier bracket.

  18. REMOVE NO. 2 AMPLIFIER BRACKET


    1. B006N4N

      Remove the 2 screws and No. 2 amplifier bracket.

  19. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY