REAR DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE NO. 3 SLIDE DOOR WEATHERSTRIP LH

    Click here

  2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  3. REMOVE REAR SPEAKER ASSEMBLY


    1. B006NGHC01
      B006N8A Remove in this Direction

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 5 mm (0.197 in.), remove the 3 rivet heads as shown in the illustration.

      Note


      • Do not touch the cone part of the rear speaker assembly.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Disengage the claw and guide to remove the rear speaker assembly.

    5. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

  4. REMOVE REAR NO. 2 SPEAKER ASSEMBLY


    1. B006OF7C01
      B006N8A Remove in this Direction

      Disconnect the connector.

    2. Disengage the claws to remove the rear No. 2 speaker assembly as shown in the illustration.

      Note

      Do not touch the cone part of the rear No. 2 speaker assembly.