HEATED STEERING WHEEL CONTROLLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering heater control assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power Slide Door System

Click here

Reset back door close position Power Back Door System

Click here

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  3. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  4. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY


    1. B006PBU

      Disengage the 6 claws of the lower steering wheel boss cover.

      Tech Tips

      Do not remove the lower steering wheel boss cover from the steering wheel sub-assembly. Loosen the lower steering boss cover.

    2. B006MWR

      Disconnect the connector.

    3. B006OUO

      Disengage the clamp.

    4. Remove the 2 screws and steering wheel heater control assembly from the lower steering wheel boss cover.