ELECTRIC PARKING BRAKE SYSTEM, Diagnostic DTC:C13A1/12

DTC Code DTC Name
C13A1/12 Short in Power Supply Relay Circuit

DESCRIPTION

The following DTCs are stored when a malfunction occurs in the parking brake ECU assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C13A1/12 Short in Power Supply Relay Circuit

Both of following conditions are met:


  1. Engine switch on (IG) or electric parking brake switch (combination switch assembly) pulled to lock side with engine switch off.

  2. Parking brake ECU assembly power source relay shorted for approximately 60 seconds.

  • Wire harness or connector

  • Electric parking brake switch (Combination switch assembly)

  • Parking brake ECU assembly

 DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

WIRING DIAGRAM

B006QVBE03

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • Before disconnecting connectors or fuses, turn the engine switch off and wait 20 seconds or more.

  • When replacing the parking brake ECU assembly, operate the electric parking brake switch (combination switch assembly) as the parking brake indicator light blinks (red) when the engine switch is first turned on (IG).

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU ASSEMBLY - IG POWER SOURCE CIRCUIT)


    1. B006NFQC06
      *a

      Front view of wire harness connector

      (to Parking Brake ECU Assembly)

      Turn the engine switch off.

    2. Disconnect the parking brake ECU assembly connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      K14-5 (IG) - Body ground Engine switch off Below 2.5 V
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT ELECTRIC PARKING BRAKE SWITCH (COMBINATION SWITCH ASSEMBLY)


    1. Remove the electric parking brake switch (combination switch assembly).

      Click here

    2. Inspect the electric parking brake switch (combination switch assembly).

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE ELECTRIC PARKING BRAKE SWITCH (COMBINATION SWITCH ASSEMBLY) Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (PARKING BRAKE ECU ASSEMBLY - ELECTRIC PARKING BRAKE SWITCH (COMBINATION SWITCH ASSEMBLY))


    1. Disconnect the G23 electric parking brake switch (combination switch assembly) connector.

    2. B006NFQC07
      *a

      Front view of wire harness connector

      (to Parking Brake ECU Assembly)

      Disconnect the K14 parking brake ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K14-20 (LCK1) - Body ground Always 10 kΩ or higher
      K14-15 (LCK2) - Body ground Always 10 kΩ or higher
      K14-19 (REL1) - Body ground Always 10 kΩ or higher
      K14-16 (REL2) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE PARKING BRAKE ECU ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR