GENERATOR INSTALLATION

PROCEDURE


  1. INSTALL GENERATOR ASSEMBLY


    1. Install the generator assembly bracket to the generator assembly with the bolt.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    2. Install the generator assembly with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

    3. Install the bolt and engage the wire harness clamp.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    4. Engage the wire harness clamp.

    5. Connect the compressor and magnetic clutch connector.

    6. Connect the generator assembly connector.

    7. Connect the wire harness to terminal B with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    8. Close the terminal cap.

    9. B006P1IC01
      *A Type A
      *B Type B
      *a 18 mm (0.7087 in.)
      *b 16 mm (0.630 in.)

      Connect the wire harness with the 2 bolts.

      Torque:
      Type A
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }
      Type B
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL V-RIBBED BELT

    Click here

  3. INSTALL RADIATOR ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here