FRONT DRIVE SHAFT ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | REAR ENGINE UNDER COVER LH | *2 | REAR ENGINE UNDER COVER RH |
ILLUSTRATION
| *1 | FRONT AXLE SHAFT NUT | *2 | FRONT DRIVE SHAFT ASSEMBLY |
| *3 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY | *4 | FRONT SPEED SENSOR |
| *5 | FRONT STABILIZER LINK ASSEMBLY | *6 | TIE ROD END SUB-ASSEMBLY |
| *7 | FRONT AXLE ASSEMBLY | *8 | COTTER PIN |
| *9 | FRONT FLEXIBLE HOSE | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants to the threaded parts | - | - |
ILLUSTRATION
| *1 | FRONT DRIVE SHAFT ASSEMBLY LH | *2 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *3 | FRONT DRIVE SHAFT HOLE SNAP RING | *4 | FRONT DRIVE SHAFT OIL SEAL LH |
| *5 | FRONT DRIVE SHAFT OIL SEAL RH | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
for 2AR-FE: Toyota Genuine CVT Fluid FE for 2GR-FKS: ATF WS |
 |
MP grease |
 |
for 2GR-FKS: Toyota genuine oil seal side lip grease |
- | - |
ILLUSTRATION
| *A | for LH Side | *B | for 2AR-FE |
| *C | for 2GR-FKS | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT | *2 | FRONT AXLE INBOARD JOINT BOOT CLAMP |
| *3 | FRONT AXLE OUTBOARD JOINT BOOT | *4 | FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
| *5 | FRONT DRIVE INBOARD JOINT ASSEMBLY | *6 | FRONT DRIVE SHAFT DAMPER |
| *7 | FRONT DRIVE SHAFT DAMPER CLAMP | *8 | FRONT DRIVE SHAFT DUST COVER LH |
| *9 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP | *10 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP |
| *11 | SHAFT SNAP RING | *12 | TRIPOD JOINT |
| *13 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | for RH Side | *B | for 2AR-FE |
| *C | for 2GR-FKS | - | - |
| *1 | DRIVE SHAFT BEARING CASE SUB-ASSEMBLY | *2 | FRONT AXLE INBOARD JOINT BOOT |
| *3 | FRONT AXLE INBOARD JOINT BOOT CLAMP | *4 | FRONT AXLE OUTBOARD JOINT BOOT |
| *5 | FRONT AXLE OUTBOARD JOINT BOOT CLAMP | *6 | FRONT DRIVE INBOARD JOINT ASSEMBLY |
| *7 | FRONT DRIVE SHAFT DUST COVER RH | *8 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
| *9 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP | *10 | DRIVE SHAFT BEARING CASE SNAP RING |
| *11 | FRONT DRIVE SHAFT BEARING | *12 | SHAFT SNAP RING |
| *13 | TRIPOD JOINT | *14 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY |
| *15 | SNAP RING | *16 | DRIVE SHAFT BEARING CASE |
| ● | Non-reusable part | - | - |