VACUUM SENSOR ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL CHECK VALVE GROMMET

   
   

   1. Install a new check valve grommet to the brake booster assembly.

2. INSTALL VACUUM SENSOR

   
   
   1. 

      *a	45° +/- 10°
      	Up

      Install the vacuum sensor to the brake booster assembly so that the vacuum sensor is angled as shown in the illustration.

   2. Connect the connector to the vacuum sensor.

3. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

   Click here

4. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

   Click here

5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

   Click here

6. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

   Click here

7. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

8. INSPECT WASHER NOZZLE

   Click here