VACUUM SENSOR ASSEMBLY REMOVAL

PROCEDURE

1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

2. SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

   Click here

3. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

   Click here

4. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

   Click here

5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

   Click here

6. REMOVE VACUUM SENSOR

   
   

   1. 

      Disconnect the connector from the vacuum sensor.

   2. 

      Remove the vacuum sensor from the brake booster assembly.

7. REMOVE CHECK VALVE GROMMET

   
   

   1. Remove the check valve grommet from the brake booster assembly.