AUTOMATIC TRANSAXLE SYSTEM MANUAL SHIFTING TEST


  1. PERFORM MANUAL SHIFTING TEST

    Tech Tips


    • Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

    • If any abnormalities are found in the following test, the problem is in the transaxle itself.


    1. A01UEQ5

      Disconnect the TCM connector.

      Tech Tips

      It is possible to deactivate the electrical shift control by disconnecting the TCM connector. The gears can then be changed mechanically with the shift lever.

    2. Drive with the TCM connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

      Shift Lever Position Gear
      P P
      R R
      D

      3rd

      No Shift (Gear will not change)

    3. Connect the TCM connector.

    4. Clear the DTCs.

      Click here


      Powertrain > ECT > Clear DTCs