VEHICLE STABILITY CONTROL SYSTEM Brake Warning Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON.

Click here

CAUTION / NOTICE / HINT

Note

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.

Click here

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output.

      for LHD: Click here

      for RHD: Click here

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    B

    CHECK CAN COMMUNICATION SYSTEM for LHD: Click here
    CHECK CAN COMMUNICATION SYSTEM for RHD: Click here

    A

  2. PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Select the Active Test on the GTS.

    6. According to the display on the GTS, perform the Active Test.


      Chassis > ABS/VSC/TRC > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Brake Warning Light Brake warning light Warning light ON/OFF

      Observe combination meter assembly

      Vehicle condition: Vehicle stopped

    7. When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.


      Chassis > ABS/VSC/TRC > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Brake Warning Light Brake warning light ON or OFF

      ON: Warning light on

      OFF: Warning light off

      		 -

      Chassis > ABS/VSC/TRC > Active Test
      Active Test Display
      Brake Warning Light
      Data List Display
      Brake Warning Light
      Result
      Result Proceed to
      Brake warning light in the Data List does not change using the Active Test. A
      Brake warning light in the Data List turns ON/OFF using the Active Test. B

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here


    A

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    B

  3. INSPECT COMBINATION METER ASSEMBLY


    1. Turn the engine switch off.

    2. Perform Active Test of the combination meter assembly using the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display
      Indicat. Lamp Brake

    3. Check the combination meter assembly.

      OK
      The brake warning light turns on or off in accordance with the GTS.
      Result
      Proceed to
      OK
      NG

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here


    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    NG

    INSPECT METER / GAUGE SYSTEM Click here