VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1433

DTC Code DTC Name
C1433 Steering Angle Sensor Internal Circuit

DESCRIPTION

The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1433 Steering Angle Sensor Internal Circuit With the +BS terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. Steering angle sensor -

CAUTION / NOTICE / HINT

Tech Tips


  • When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first.

    Click here

  • When any of the speed sensors or the yaw rate and acceleration sensor (airbag ECU assembly) has trouble, DTCs for the steering angle sensor may be output even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag ECU assembly) are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag ECU assembly) first, and then inspect and repair the steering angle sensor.

PROCEDURE


  1. REPLACE STEERING ANGLE SENSOR


    1. Replace the steering angle sensor.

      Click here

      Tech Tips

      If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END