STEERING ANGLE SENSOR

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Removal/installation of the spiral cable with sensor sub-assembly	Steering angle neutral point (Initialize panoramic view monitor system)	Panoramic View Monitor System	Click here
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and Start System (for 2AR-FE)	Click here
		Stop and Start System (for 2GR-FKS)	Click here
	Memorize steering angle neutral point	Panoramic View Monitor System	Click here
	Initialize back door lock	Power Door Lock Control System	Click here
	Initialize servo motor	Air Conditioning System	Click here
	Reset slide door close position	Power Slide Door System	Click here
	Reset back door close position	Power Back Door System	Click here

CAUTION / NOTICE / HINT

Note

If both the spiral cable sub-assembly and the steering sensor are malfunctioning, replace them with a new spiral cable with sensor sub-assembly.

PROCEDURE

REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Click here
REMOVE STEERING SENSOR
1. Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.
  
  Note
  
  Do not damage the claws and pins of the spiral cable sub-assembly.

STEERING ANGLE SENSOR REMOVAL