FUEL PRESSURE REGULATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pressure regulator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of fuel pump	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here

Note

Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.

Tube

PROCEDURE

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here
REMOVE FUEL SENDER GAUGE ASSEMBLY

Click here
REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY

Click here
REMOVE FUEL PUMP

Click here
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
1. *a Protective Tape
  
  Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel filter.
  Note
  - Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.
  - Do not damage the fuel filter.
2. *1 O-ring
  
  Remove the 2 O-rings from the fuel pressure regulator assembly.