ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | *2 | NO. 2 ENGINE UNDER COVER |
| *3 | REAR ENGINE UNDER COVER LH | *4 | REAR ENGINE UNDER COVER RH |
| *5 | FRONT LOWER BUMPER ABSORBER | - | - |
ILLUSTRATION
| *1 | RADIATOR RESERVE TANK ASSEMBLY | *2 | RADIATOR RESERVE TANK BRACKET |
| *3 | FUEL MAIN TUBE | *4 | NO. 1 FUEL PIPE CLAMP |
| *5 | NO. 2 ENGINE MOUNTING STAY RH | *6 | NO. 1 FUEL VAPOR FEED HOSE |
| *7 | NO. 2 RADIATOR HOSE | *8 | UNION TO CONNECTOR TUBE HOSE |
| *9 | NO. 1 RADIATOR HOSE | *10 | INLET HEATER WATER HOSE |
| *11 | OUTLET OIL COOLER HOSE | *12 | OUTLET HEATER WATER HOSE |
| *13 | INLET OIL COOLER HOSE | *14 | NO. 1 WATER BY-PASS HOSE |
| *15 | NO. 2 WATER BY-PASS HOSE | *16 | FUEL PIPE |
| *17 | V-RIBBED BELT | *18 | V-BANK COVER SUB-ASSEMBLY |
| *19 | TRANSMISSION CONTROL CABLE ASSEMBLY | *20 | NO. 1 RELAY BLOCK COVER |
| *21 | ENGINE ROOM RELAY BLOCK ASSEMBLY | *22 | ENGINE WIRE |
| *23 | NO. 3 ENGINE WIRE | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | FRONT ENGINE MOUNTING INSULATOR |
| *3 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *4 | FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY LH |
| *5 | FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY RH | *6 | FRONT SUSPENSION MEMBER REINFORCEMENT LH |
| *7 | FRONT SUSPENSION MEMBER REINFORCEMENT RH | *8 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY |
| *9 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY | *10 | REAR ENGINE MOUNTING INSULATOR |
| *11 | FRONT CROSSMEMBER SUB-ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | DRIVE SHAFT BEARING BRACKET | *2 | ENGINE ASSEMBLY WITH TRANSAXLE |
| *3 | ENGINE MOUNTING INSULATOR LH | *4 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
| *5 | ENGINE WIRE | *6 | FRONT ENGINE MOUNTING BRACKET |
| *7 | FRONT EXHAUST PIPE ASSEMBLY | *8 | FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
| *9 | MANIFOLD STAY | *10 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) |
| *11 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Upper Side) | *12 | EXHAUST PIPE GASKET |
| *13 | COMPRESSION SPRING | *14 | COOLER BRACKET |
| *15 | WIRE HARNESS BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT | *2 | FRONT DRIVE PLATE SPACER |
| *3 | BRACKET | *4 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
| *5 | REAR DRIVE PLATE SPACER | *6 | FLYWHEEL HOUSING UNDER COVER |
| *7 | GENERATOR ASSEMBLY | *8 | TRANSMISSION BREATHER SKIRT |
| *9 | O-RING | *10 | STARTER ASSEMBLY |
| *11 | AUTOMATIC TRANSAXLE ASSEMBLY | *12 | NO. 1 COOLER REFRIGERANT SUCTION HOSE |
| *13 | COMPRESSOR AND MAGNETIC CLUTCH | *14 | NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
| *15 | ENGINE WIRE | - | |
| *a | BLACK: x 1 SILVER: x 5 |
- | |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Adhesive 1324 |  |
Compressor oil ND-OIL 8 or equivalent |
| ★ | Precoated part | - |