CYLINDER HEAD GASKET REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head gasket removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of ECM	Perform Vehicle Identification Number (VIN) or frame number registration	MIL illuminates DTC P0630 is stored	Click here
	ECU Communication ID Registration (Immobiliser system)	Engine start function	See Service Bulletin for the registration method.
	Perform code registration (Immobiliser system)	Wireless door lock control system Smart entry and start system Engine start function Steering lock system	See Service Bulletin for the registration method.
Replacement of engine assembly Gas leak from exhaust system is repaired Replacement of cylinder head sub-assembly Replacement of camshaft (for intake or exhaust camshaft) Replacement of camshaft timing gear assembly Replacement of camshaft timing exhaust gear assembly Replacement of ignition coil assembly	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here
Replacement of automatic transaxle assembly	Perform the following procedures in the order shown: Reset Memory Input Transaxle Compensation Code into TCM Perform Road Test to Allow TCM to Learn	Large shift shock Deterioration of fuel efficiency	Click here for Initialization Click here for Registration
Front wheel alignment adjustment	Clear zero point calibration data and store system information. Perform yaw rate and acceleration sensor zero point calibration and store system information.	VSC disabled or malfunctions DTCs are stored Slip indicator light illuminates ABS warning light illuminates	Click here
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components	Initialize headlight light control ECU sub-assembly LH	Headlight leveling function	Click here
Removal/installtaion of the radiator grille	Television camera view adjustment	Panoramic view monitor system	Click here

PROCEDURE

REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH

Click here
REMOVE NO. 1 CHAIN VIBRATION DAMPER

Click here
REMOVE NO. 2 CHAIN VIBRATION DAMPER

Click here
REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

Click here
REMOVE VALVE LASH ADJUSTER ASSEMBLY

Click here
REMOVE VALVE STEM CAP

Click here
REMOVE WATER OUTLET

Click here
REMOVE CYLINDER HEAD SUB-ASSEMBLY

Click here
REMOVE CYLINDER HEAD GASKET
1. Remove the cylinder head gasket.
REMOVE CYLINDER HEAD LH

Click here
REMOVE NO. 2 CYLINDER HEAD GASKET
1. Remove the No. 2 cylinder head gasket.
INSPECT CYLINDER HEAD SET BOLT

Click here