DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT


    1. B006Q0NC01
      *1 Engine Water Pump Assembly
      *2 No. 2 Idler Pulley Sub-assembly
      *3 Generator Assembly
      *4 Crankshaft Pulley
      *5 V-ribbed Belt Tensioner Assembly
      *6 Compressor Assembly with Pulley

      Install the V-ribbed belt.

      Note


      • Make sure to put the backside of the V-ribbed belt on the V-ribbed belt tensioner pulley and No. 2 idler pulley sub-assembly.

      • Check that the V-ribbed belt is properly set to each pulley.

    2. Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

    3. B006P93C01
      *a Correct
      *b Incorrect

      After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

  2. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  3. INSTALL FRONT WHEEL RH

    Click here