HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  2. REMOVE HEATED OXYGEN SENSOR (for Bank 1)

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

    B006O6C

    1. B006NMF

      Disconnect the heated oxygen sensor connector.

    2. B006QN0

      Disengage the heated oxygen sensor grommet from the vehicle body.

    3. Disengage the wire harness clamp.

    4. B006PRRN01

      Using SST, remove the heated oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00012

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

  3. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

  4. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  6. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    1. B006LQEN01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00012