HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 2)


    1. B006P8ZC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

  2. INSTALL FRONT EXHAUST PIPE ASSEMBLY

  3. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

  4. INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY

  5. INSTALL HEATED OXYGEN SENSOR (for Bank 1)


    1. B006R60C01
      *a Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Engage the wire harness clamp.

    3. Engage the heated oxygen sensor grommet to the vehicle body.

    4. Connect the heated oxygen sensor connector.

  6. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK