IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


  2. SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY


  3. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL


  4. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL


  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


  6. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  7. REMOVE IGNITION COIL ASSEMBLY


    1. B006LHW

      Disconnect the 6 ignition coil assembly connectors.

    2. Remove the 6 bolts and 6 ignition coil assemblies from the cylinder head cover sub-assembly.

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.

  8. REMOVE SPARK PLUG


    1. B006M0W

      Remove the 6 spark plugs from the cylinder head sub-assembly.

      Note

      If a spark plug has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.