ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

  2. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B006ML9

      Disconnect the engine coolant temperature sensor connector.

    2. Remove the clip and engine coolant temperature sensor from the water outlet.

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.