KNOCK SENSOR INSTALLATION

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

   Tech Tips

   Perform "Inspection After Repair" after replacing a knock control sensor.

   Click here

   
   
   1. 

      *A	for Bank 1
      *B	for Bank 2
      *a	Front of Vehicle
      *b	5°
      *c	10°

      Install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note

      
      

      • If a knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

   2. Connect the 2 knock control sensor connectors.

2. INSTALL INTAKE MANIFOLD

   Click here

3. PERFORM INITIALIZATION

   
   

   1. Perform "Inspection After Repair" after replacing a knock control sensor.

      Click here