IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of throttle body with motor assembly	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here
Cleaning the deposits from the throttle body with motor assembly
Replacement of ignition coil assembly
Replacement of spark plug

PROCEDURE

REMOVE INTAKE AIR SURGE TANK ASSEMBLY

Click here
REMOVE IGNITION COIL ASSEMBLY
1. Disengage the 3 wire harness clamps.
2. Disconnect the 6 ignition coil assembly connectors.
3. Remove the 6 bolts and 6 ignition coil assemblies from the cylinder head cover sub-assembly.
  
  Note
  
  If an ignition coil assembly has been struck or dropped, replace it.
  
  Tech Tips
  
  Arrange the removed parts in the correct order.
REMOVE SPARK PLUG
1. Remove the 6 spark plugs from the cylinder head sub-assembly.
  
  Note
  
  If a spark plug has been struck or dropped, replace it.
  
  Tech Tips
  
  Arrange the removed parts in the correct order.