CRANKSHAFT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the crankshaft position sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Battery terminal is disconnected/reconnected	Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Initialize servo motor	Air conditioning system	Click here
	Reset slide door close position	Power slide door system	Click here
	Reset back door close position	Power back door system	Click here

PROCEDURE

REMOVE COMPRESSOR AND MAGNETIC CLUTCH

Click here
REMOVE CRANKSHAFT POSITION SENSOR
1. Disconnect the crankshaft position sensor connector.
2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
  
  Note
  
  If the crankshaft position sensor has been struck or dropped, replace it.