CAMSHAFT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the camshaft position sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Initialize servo motor Air conditioning system

Click here

Reset slide door close position Power slide door system

Click here

Reset back door close position Power back door system

Click here

Replacement of throttle body with motor assembly Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

Cleaning the deposits from the throttle body with motor assembly

PROCEDURE


  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  2. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    1. B006P2Y

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

      Note

      If the VVT sensor has been struck or dropped, replace it.

  3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    1. B006KZD

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

      Note

      If the VVT sensor has been struck or dropped, replace it.

  4. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    1. B006Q81

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.

      Note

      If the VVT sensor has been struck or dropped, replace it.

  5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    1. B006NZO

      Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.

      Note

      If the VVT sensor has been struck or dropped, replace it.