SFI SYSTEM FREEZE FRAME DATA

*1	DTC stored
*2	0.5 seconds
*3	Freeze frame data which can be read

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

• 3 data sets before the DTC was stored.

• 1 data set when the DTC was stored.

• 1 data set after the DTC was stored.

These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.

1. Connect the GTS to the DLC3.

2. Turn the engine switch on (IG).

3. Turn the GTS on.

4. Enter the following menus: Powertrain / Engine / Trouble Codes.

   
   Powertrain > Engine > Trouble Codes

5. Select a DTC in order to display its pending freeze frame data.

   Tech Tips

   
   

   • Pending freeze frame data is cleared when any of the following occurs.

   
   

   • DTCs are cleared using the GTS.

   
   

   • The cable is disconnected from the negative (-) battery terminal.

   
   

   • 40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)

   • With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new data of the newly detected DTC in the next trip.