POWER MIRROR CONTROL SYSTEM(w/o Memory) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body / Main Body / Data List.

    5. According to the display on the GTS, read the Data List.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Mirror Selection SW (R) Mirror select switch signal for RH mirror ON/OFF

      ON: Mirror select switch R switch on

      OFF: Mirror select switch R switch off

      		 Only item displayed (not supported)
      Mirror Selection SW (L) Mirror select switch signal for LH mirror ON/OFF

      ON: Mirror select switch L switch on

      OFF: Mirror select switch L switch off

      		 Only item displayed (not supported)
      Mirror Position SW (R) Mirror surface adjust switch signal (Right) ON/OFF

      ON: Mirror surface adjust switch pressed right

      OFF: Mirror surface adjust switch not pressed right

      		 Only item displayed (not supported)
      Mirror Position SW (L) Mirror surface adjust switch signal (Left) ON/OFF

      ON: Mirror surface adjust switch pressed left

      OFF: Mirror surface adjust switch not pressed left

      		 Only item displayed (not supported)
      Mirror Position SW (Up) Mirror surface adjust switch signal (Up) ON/OFF

      ON: Mirror surface adjust switch pressed up

      OFF: Mirror surface adjust switch not pressed up

      		 Only item displayed (not supported)
      Mirror Position SW (Dwn) Mirror surface adjust switch signal (Down) ON/OFF

      ON: Mirror surface adjust switch pressed down

      OFF: Mirror surface adjust switch not pressed down

      		 Only item displayed (not supported)
      Outer Mirror Fold SW Mirror retract switch signal ON/OFF

      ON: Mirror retract switch in retract position

      OFF: Mirror retract switch not in retract position

      		 -
      Outer Mirror Return SW Mirror retract switch signal ON/OFF

      ON: Mirror retract switch in return position

      OFF: Mirror retract switch not in return position

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / (desired system) / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Main Body > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Mirror Fold Mirror retract operation FOLD / OFF -
      Mirror Return Mirror retract operation RETURN / OFF -

      Body Electrical > Air Conditioner > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Defogger Relay (Rear) Mirror Heater OFF/ON w/ Mirror Heater