BACK DOOR SUPPORT INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL BACK DOOR UPPER DAMPER STAY BRACKET LH


    1. When replacing the back door stay bolt with a new one:


      1. Clean the threaded portion on the vehicle body with non-residue solvent.

    2. When reusing the back door stay bolt:


      1. Clean the threaded portion on the vehicle body with non-residue solvent.

      2. Apply adhesive to the threads of the 2 bolts.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    3. A01HI9EN01

      Temporarily install the back door damper stay upper bracket LH.

    4. Tighten the 2 bolts to install the back door damper stay upper bracket LH.

      Tech Tips

      Tighten the 2 bolts in the order shown in the illustration.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  2. INSTALL BACK DOOR LOWER DAMPER STAY BRACKET LH


    1. When replacing the back door stay bolt with a new one:


      1. Clean the threaded portion on the vehicle body with non-residue solvent.

    2. When reusing the back door stay bolt:


      1. Clean the threaded portion on the vehicle body with non-residue solvent.

      2. Apply adhesive to the threads of the 2 bolts.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    3. A01HIUBN01

      Temporarily install the back door lower damper stay bracket LH.

    4. Tighten the 2 bolts to install the back door lower damper stay bracket LH.

      Tech Tips

      Tighten the 2 bolts in the order shown in the illustration.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  3. INSTALL BACK DOOR STAY ASSEMBLY LH


    1. When reusing the back door stay assembly LH:


      1. A01HHAN

        Install the back door stay assembly LH with the 2 stop rings.

    2. A01HIY1

      Install the back door stay assembly LH.

      Note


      • Install the back door stay assembly while supporting the back door by hand.

      • Check that the back door stay assembly is engaged in the ball joint and that the back door support assembly cannot be pulled out.