POWER BACK DOOR DRIVE UNIT REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE BACK DOOR CENTER GARNISH

    Click here

  2. REMOVE BACK DOOR SIDE GARNISH LH

    Click here

  3. REMOVE BACK DOOR SIDE GARNISH RH

    Click here

  4. REMOVE BACK DOOR TRIM BASE

    Click here

  5. REMOVE PULL HANDLE

    Click here

  6. REMOVE BACK DOOR LOCK COVER

    Click here

  7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  8. REMOVE POWER BACK DOOR UNIT ASSEMBLY SET LH


    1. B0057B2

      Disconnect the connector.

    2. Detach the grommet.

    3. Remove the 4 bolts and power back door unit assembly set LH.

  9. REMOVE BACK DOOR LOWER DAMPER STAY BRACKET LH


    1. B0059Y5

      Perform this procedure when replacing only the back door lower damper stay bracket LH.


      1. Using a 3 mm pin punch and hammer, tap out the pin from the joint.

      2. B0057W8

        Remove the joint and protector cover.