REAR DOOR INSPECTION

PROCEDURE


  1. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. A01HGBDC01
      *a

      Component without harness connected

      (Rear Door Outside Handle Assembly LH)

      Check that the LED illuminates.


      1. Apply 6.0 V (4 dry cell batteries in series) to each terminal and check the illumination state of the light.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (OLP)

        Battery negative (-) → 3 (GND)

        		 LED illuminates

        Note

        Do not apply more than 6.0 V.

        If the result is not as specified, replace the rear door outside handle assembly LH.

  2. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH


    1. A01HGBDC01
      *a

      Component without harness connected

      (Rear Door Outside Handle Assembly RH)

      Check that the LED illuminates.


      1. Apply 6.0 V (4 dry cell batteries in series) to each terminal and check the illumination state of the light.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (OLP)

        Battery negative (-) → 3 (GND)

        		 LED illuminates

        Note

        Do not apply more than 6.0 V.

        If the result is not as specified, replace the rear door outside handle assembly RH.