POWER BACK DOOR SYSTEM FREEZE FRAME DATA


  1. FREEZE FRAME DATA


    1. Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.

  2. CHECK FREEZE FRAME DATA


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Back Door / Trouble Codes.


      Body Electrical > Back Door
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Half Latch SW Latch switch signal ON or OFF

      ON: Back door lock motor open-latched

      OFF: Back door lock motor full-latched or half-latched

      		 Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
      Closer Position SW Initial switch signal ON or OFF

      ON: Back door lock center gear in center position (Initial switch on)

      OFF: Back door lock center gear out of center position (Initial switch off)

      		 Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
      Courtesy SW Back door courtesy switch signal ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
      Back Door Position Status of the back door position -4000 to 21500 Edge 3000 to 6000 Edge -
      Back Door Horizontal Torsion Status of the torsion between back door LH and RH -128 to 127 Edge -128 to 127 Edge -
      Battery Voltage Status of the battery voltage 0 to 31 V 11 to 14 V -
      Closer Control Status Status of the closer control Initialize, "Close 1: Standby", "Close 2: Operate Standby", "Close 3: Operation", "Close 4: Return Standby", "Close 5: Return", "Release 1: Standby", "Release 2: Operation", "Release 3: Return Standby", "Release 4: Return", "Forcible 1: Release Operation", "Forcible 2: Close Standby", "Forcible 3: Close Operation Standby", "Forcible 4: Close Operation", "Forcible 5: Closer Torque Moderate", "Forcible 6: Door Check" or Stop Function Status of the closer control -
      PBD Control Status Status of the power back door system control All Close Initialize, All Close, "Open 1: Auto Open Standby", "Open 2: Latch Release Standby", "Open 3: Auto Open Operation", All Open, "Close 1: Auto Close Standby", "Close 2: Auto Close Operation", "Close 3: Closer Start Standby", "Close 4: All Close Standby", Neutral, Auto Close Reverse or Brake Status of the power back door system control -
      #Codes Number of DTCs Min.: 0, Max.: 255

      When system is normal: 0

      When a malfunction is detected: More than 0

      		 -

      • *: Refer to "POWER BACK DOOR OPERATION TIMING CHART"

        Click here

  3. CLEAR FREEZE FRAME DATA

    Note

    Clearing the DTCs will also clear the Freeze Frame Data.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Clear the DTCs and Freeze Frame Data.