POWER WINDOW REGULATOR MOTOR(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 "TORX" screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR REAR GUIDE SEAL RH

    Click here

  5. INSTALL REAR LOWER REAR DOOR WINDOW FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR GLASS RUN LH

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. INSTALL REAR DOOR ARMREST SET BRACKET LH

    Click here

  9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL REAR DOOR TRIM COVER LH

    Click here

  11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  12. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  14. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  15. CHECK POWER WINDOW

    Click here