ROOF SUNSHADE SWITCH INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY (ROOF SUNSHADE SWITCH)


    1. A01HHV9C01
      *a

      Component without harness connected

      (Map Light Assembly (Roof Sunshade Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      11 (OPN) - 19 (GND) Open switch is pressed Below 1 Ω
      11 (OPN) - 19 (GND) Open switch is not pressed 10 kΩ or higher
      12 (CLS) - 19 (GND) Close switch is pressed Below 1 Ω
      12 (CLS) - 19 (GND) Close switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the map light assembly (roof sunshade switch).