REAR SEAT CUSHION HEATER(for Manual Seat) INSPECTION

PROCEDURE


  1. INSPECT BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY RH)


    1. B0058N5C02
      *a Connector A
      *b Connector B
      *c

      Component without harness connected

      (Bench Type Rear Seat Cushion Cover (Rear Seat Cushion Heater Assembly RH))

      Check the bench type rear seat cushion cover (rear seat cushion heater assembly RH).

      Note

      Disconnect the connector B from the rear seat cushion heater assembly LH before checking it.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        A-1 - B-1 Always (23°C) Below 1 Ω
        A-1 - B-2 73.9 to 90.4 Ω
        A-1 - B-3
        A-1 - A-4 3.34 to 4.08 Ω
        A-1 - A-5
        A-1 - A-6 Below 1 Ω
        A-2 - A-3 7.52 to 9.19 kΩ
        A-4 - B-1 3.34 to 4.08 Ω
        A-4 - B-2 77.3 to 94.4 Ω
        A-4 - B-3
        A-4 - A-5 Below 1 Ω
        A-4 - A-6 3.34 to 4.08 Ω
        A-5 - B-1
        A-5 - B-2 77.3 to 94.4 Ω
        A-5 - B-3
        A-5 - A-6 3.34 to 4.08 Ω
        A-6 - B-1 Below 1 Ω
        A-6 - B-2 73.9 to 90.4 Ω
        A-6 - B-3
        B-1 - B-2
        B-1 - B-3
        B-2 - B-3 Below 1 Ω

        If the result is not as specified, replace the bench type rear seat cushion cover (rear seat cushion heater assembly RH).

  2. INSPECT BENCH TYPE REAR SEAT CUSHION COVER (REAR SEAT CUSHION HEATER ASSEMBLY LH)


    1. B005873C02
      *a Connector A
      *b Connector B
      *c

      Component without harness connected

      (Bench Type Rear Seat Cushion Cover (Rear Seat Cushion Heater Assembly LH))

      Check the bench type rear seat cushion cover (rear seat cushion heater assembly LH).

      Note

      Disconnect the connector B from the rear seat cushion heater assembly RH before checking it.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        A-1 - B-1 Always (23°C) Below 1 Ω
        A-1 - B-2 3.34 to 4.08 Ω
        A-1 - A-4
        A-2 - A-3 7.52 to 9.19 kΩ
        A-4 - B-1 3.34 to 4.08 Ω
        A-4 - B-2 Below 1 Ω
        A-5 - B-3
        B-1 - B-2 3.34 to 4.08 Ω

        If the result is not as specified, replace the bench type rear seat cushion cover (rear seat cushion heater assembly LH).