FRONT SEATBACK HEATER(for Manual Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER LH

    Tech Tips


    • When installing the seat cover, refer to the precautions in order to prevent wrinkles from forming.

      Click here


    • Align the seam allowance in a single direction as shown in the illustration.

    B005AOMN01

    1. B005ALUC01
      *1 Hog Ring Pliers

      Using hog ring pliers, install the separate type front seatback cover LH to the separate type front seatback pad LH with 14 new hog rings in the order indicated in the illustration.

      Note


      • Be careful not to damage the separate type front seatback cover.

      • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.


      1. B0059X8

        Pass the 3 seatback cover brackets through the 3 holes of the separate type front seatback pad.

        Note

        After the seatback cover bracket is installed, make sure the seatback cover bracket is not twisted.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    1. Temporarily install the separate type front seatback cover with pad.

    2. Connect the 3 seatback cover brackets with the 2 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note


      • For vehicles with a front seat airbag assembly, the separate type front seatback cover with pad must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.


      • Make sure that the strap is not twisted after installing the nut.


      • Install the brackets securely.

    3. B00580X

      Attach the clamp to connect the seat heater wire harness.

    4. Connect the connector.

  3. INSTALL FRONT SEAT HEADREST SUPPORT

    Click here

  4. INSTALL FRONT INNER SEAT CUSHION SHIELD LH

    Click here

  5. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  6. INSTALL VERTICAL ADJUSTING HANDLE LH

    Click here

  7. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  8. INSTALL FRONT SEAT ASSEMBLY LH

    Click here