SEAT POSITION SENSOR(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  5. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  7. REMOVE SEAT POSITION AIRBAG SENSOR


    1. B00577S

      Disconnect the connector.

    2. Detach the 2 wire harness clamps.

    3. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor together with the seat slide position sensor protector.

      Note

      The "TORX" bolt must not be reused.

    4. B0058DB

      Detach the guide and remove the seat slide position sensor protector.