CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL AIRBAG ECU ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B00599TC01
      *1 Connector Lock
      *2 Waterproof Sheet

      Check that the waterproof sheet is properly set.

    4. Install the airbag ECU assembly with the 3 bolts.

      Torque:
      17.5 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.

      • When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the engine switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.

    5. Connect the airbag connector and push the connector lock to lock the airbag connector.

      Note


      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Do not allow the water proof sheet to become pinched.

    6. Check that there is no looseness in the installation parts of the airbag ECU assembly.

  2. INSTALL FRONT CONSOLE BOX

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here