CENTER AIRBAG SENSOR ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT CONSOLE BOX

    Click here

  4. REMOVE AIRBAG ECU ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B005934C01
      *1 Connector Lock Lever
      *2 Waterproof Sheet

      Disconnect the airbag connector.

      Note


      • When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      • Do not remove the waterproof sheet.


      1. Push and pull the connector lock lever to release the connector lock as shown in the illustration.

      2. Disconnect the airbag connector.

    4. B005AQ8

      Remove the 3 bolts and airbag ECU assembly.

      Note

      If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag ECU assembly with a new one.