SRS SEAT CUSHION AIRBAG ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat cushion airbag assembly RH was deployed, replace the parts indicated in the chart below according to the specification.

    for L-Sport for F-Sport

    Front seat cushion airbag assembly

    Separate type front seat cushion cover

    Separate type front seat cushion pad

    Front seat cushion spring sub-assembly

    Front seat adjuster assembly

    Front seat cushion airbag assembly

    Front seat cushion with cover pad

    Front seat cushion spring sub-assembly

    Front seat adjuster assembly

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  4. REMOVE FRONT SEAT LOWER CUSHION SHIELD

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

    Click here

  7. REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD (for L-Sport)

    Click here

  8. REMOVE FRONT SEAT CUSHION WITH COVER PAD RH (for F-Sport)

    Click here

  9. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH


    1. B0057BE

      Detach the 3 wire harness clamps.

    2. Detach the claw and disconnect the airbag connector.

    3. B0058HF

      Detach the 3 wire harness clamps.

    4. Remove the 3 nuts and front seat cushion airbag assembly RH.

      CAUTION:


      • The nuts must not be reused.

      • When storing the front seat cushion airbag assembly RH, keep the airbag deployment side facing upward.

      • Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.