FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat side airbag was deployed, replace the parts indicated in the chart below according to the specification.

    for L-Sport for F-Sport

    Front seat airbag assembly

    Separate type front seatback spring assembly

    Seatback felt

    Separate type front seatback pad

    Separate type front seatback cover

    Front seat airbag assembly

    Separate type front seatback spring assembly

    Seatback felt

    Front seatback with cover pad

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH


    1. Install the front seat airbag assembly LH with 2 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:


      • The nuts must not be reused.

      • Make sure that the front seatback spring sub-assembly is not deformed. If it is, replace it with a new one.

    2. Attach the 2 wire harness clamps and fastener.

    3. Attach the claw to connect the airbag connector.

    4. Attach the 3 wire harness clamps.

  2. INSTALL SEATBACK FELT

    Click here

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for L-Sport)

    Click here

  4. INSTALL FRONT SEATBACK WITH COVER PAD LH (for F-Sport)

    Click here

  5. INSTALL FRONT SEAT HEADREST SUPPORT

    Click here

  6. INSTALL FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  7. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  8. INSTALL FRONT SEAT LOWER CUSHION SHIELD

    Click here

  9. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  12. CHECK SRS WARNING LIGHT

    Click here