FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • If the front seat side airbag was deployed, replace the front seat airbag assembly, seatback felt, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  5. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  7. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  8. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  10. REMOVE SEATBACK FELT

    Click here

  11. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH


    1. B005AW0

      for Driver Side:


      1. Detach the 4 wire harness clamps.

      2. Detach the claw and disconnect the airbag connector.

    2. B00574Y

      for Front Passenger Side:


      1. Detach the 4 wire harness clamps.

      2. Detach the claw and disconnect the airbag connector.

    3. B005938

      Detach the fastener and 2 wire harness clamps.

    4. B00595B

      Remove the 2 nuts and front seat airbag assembly LH.

      CAUTION:


      • The nuts must not be reused.

      • When storing the front seat airbag assembly LH, keep the airbag deployment side facing upward.

      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.