CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


    1. A01XNBQC02
      *1 Pin

      Attach the 2 claws to install a new clip to the curtain shield airbag assembly LH.

      Note

      At this time, do not push in the pin to lock the clip.

      Tech Tips

      Use the same procedure for the other clips.

    2. Check that the engine switch is off.

    3. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    4. Attach the 2 hooks and 2 claws and set the vehicle rear side deployment portion of the curtain shield airbag assembly LH.

    5. Temporarily install the 3 new bolts in the order shown in the illustration.

    6. Attach the 2 claws and connect the vehicle front side deployment portion of the curtain shield airbag assembly LH.

    7. Attach the 2 claws to connect the clip.

      Tech Tips

      Use the same procedure for the other clips.

    8. Check that the deployment portion of the curtain shield airbag assembly LH is not twisted.

    9. Tighten the 3 bolts in the order shown in the illustration.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      A01XO1LC02
      *a Vehicle Rear Side Deployment Portion *b Vehicle Front Side Deployment Portion

    10. Push in the pin to lock the clip.

      Tech Tips

      Use the same procedure for the other pins.

      A01XOVRC01
      *1 Pin - -

    11. Lightly pull on the clip to check whether it is locked.

      Tech Tips

      Use the same procedure for the other clips.

    12. B005ASCC01
      *1 Connector Lock

      Connect the airbag connector and push the connector lock.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here