CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    CAUTION:

    When storing the curtain shield airbag assembly LH, keep the airbag deployment side facing upward.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0059ITC01
      *1 Connector Lock
      B0057KY Protective Tape

      Using a screwdriver, pull up the connector lock and disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      Tech Tips

      Tape the screwdriver tip before use.

    4. A01XPIIC01
      *1 Pin

      Using needle-nose pliers, release the lock by pinching the 2 locks of the pin, and then pull out the pin from the clip.

      Note

      The pins must not be reused.

      Tech Tips

      Use the same procedure for the other pins.

    5. B005AT0

      Using 2 screwdrivers, detach the 2 clips by inserting the screwdrivers into the grooves of the clips as shown in the illustration, and then disconnect the clips from the vehicle body.

      Tech Tips

      Use the same procedure for the other clips.

    6. Detach the 2 claws and disconnect the vehicle front side deployment portion of the curtain shield airbag assembly LH.

    7. Remove the 3 bolts.

      Note

      The bolts must not be reused.

    8. Detach the 2 hooks and 2 claws and remove the curtain shield airbag assembly LH.

      A01XO1LC01
      *a Vehicle Front Side Deployment Portion - -
    9. B0059K0

      Detach the 2 claws and remove the clip from the curtain shield airbag assembly LH.

      Note

      The clips must not be reused.

      Tech Tips

      Use the same procedure for the other clips.