BLOCKING SYSTEM, Diagnostic DTC:B15C0, B15C1

DTC Code DTC Name
B15C0 Short in GPS Antenna
B15C1 Open in GPS Antenna

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly (GPS antenna) circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C0 Short in GPS Antenna A short circuit in the navigation antenna assembly between the telephone transceiver assembly and navigation antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and navigation antenna assembly is detected.

  • Telephone transceiver assembly

  • Navigation antenna assembly (GPS antenna)

  • Harness or connector
B15C1 Open in GPS Antenna An open circuit in the navigation antenna assembly between the telephone transceiver assembly and navigation antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and navigation antenna assembly is detected.

  • Telephone transceiver assembly

  • Navigation antenna assembly (GPS antenna)

  • Harness or connector

CAUTION / NOTICE / HINT

Note


  • When replacing the telephone transceiver assembly or navigation antenna assembly, refer to Service Bulletin.

  • When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

PROCEDURE


  1. CHECK CONNECTION OF CONNECTORS


    1. Turn the engine switch off.

    2. Check that the connectors are properly connected to the telephone transceiver assembly and navigation antenna assembly (GPS antenna) connector.

      OK
      Connectors are properly connected.
      Result
      Proceed to
      OK
      NG

    NG

    CONNECT CONNECTORS CORRECTLY

    OK

  2. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Telematics > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTC


    1. Check for DTCs.

      Click here


      Body Electrical > Telematics > Trouble Codes
      OK
      DTCs B15C0 and B15C1 are not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  4. CHECK CONNECTOR CONDITION


    1. Turn the engine switch off.

    2. Disconnect the I179 telephone transceiver assembly (GPS antenna) connector.

      B0057L5C02
      *a

      Component without harness connected

      (Telephone Transceiver Assembly)

      		 *b GPS Antenna

    3. Check that the connector pins are not bent.

      OK
      Connector pins are not bent.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

    OK

  5. CHECK NAVIGATION ANTENNA ASSEMBLY (TELEPHONE ANTENNA)


    1. B0059V1C02
      *a

      Component without harness connected

      (Navigation Antenna Assembly (GPS Antenna))
      *b Core Wire
      *c Shield

      Disconnect the I179 telephone transceiver assembly (GPS antenna) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Core wire - Shield Always 50 to 500 Ω
      Result
      Proceed to
      OK
      NG

    NG

    CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - NAVIGATION ANTENNA ASSEMBLY) Click here

    OK

  6. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Telematics > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  7. CHECK FOR DTC


    1. Check for DTCs.

      Click here


      Body Electrical > Telematics > Trouble Codes
      OK
      DTCs B15C0 and B15C1 are not output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

    REPLACE NAVIGATION ANTENNA ASSEMBLY Click here

  8. CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - NAVIGATION ANTENNA ASSEMBLY)


    1. Disconnect the I179 telephone transceiver assembly (GPS antenna) connector.

    2. Disconnect the I177 navigation antenna assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I179-1 (GPS) - I177-3 (GPS) Always Below 1 Ω
      I179-1 (GPS) - Body ground Always 10 kΩ or higher
      I177-3 (GPS) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE NAVIGATION ANTENNA ASSEMBLY

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  9. REPLACE NAVIGATION ANTENNA ASSEMBLY


    1. Temporarily replace the navigation antenna assembly with a new or known good one.

      Tech Tips

      Refer to Service Bulletin.

      Result
      Proceed to
      NEXT

    NEXT

  10. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Telematics > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  11. CHECK FOR DTC


    1. Check for DTCs.

      Click here


      Body Electrical > Telematics > Trouble Codes
      OK
      DTCs B15C0 and B15C1 are not output.
      Result
      Proceed to
      OK
      NG

    OK

    END (NAVIGATION ANTENNA ASSEMBLY WAS DEFECTIVE)

    NG

    REPLACE TELEPHONE TRANSCEIVER ASSEMBLY