ENTRY AND START SYSTEM(for Entry Function) Entry Lock Function does not Operate Using Close & Lock Function

DESCRIPTION

If the back door does not lock when using the power back door close and lock function, there may be communication problem between the certification ECU (smart key ECU assembly) and multiplex network door ECU.

CAUTION / NOTICE / HINT

Note


  • The entry and start system (for Entry Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

    Click here

  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • After repair, confirm that no DTCs are output.

  • Check that there are no electrical key transmitter sub-assemblies in the vehicle.

  • Make sure that the electrical key transmitter sub-assembly is within the power back door close and lock function operating range when performing a back door close and lock operation.

    Click here

PROCEDURE


  1. CHECK OPERATION HISTORY


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Entry&Start / Utility / Operation History


      Body Electrical > Entry&Start > Utility
      Tester Display
      Operation History
      Auto Entry Wireless Operation History
      Parameter Name Content
      Back Door Lock & Close signal Certification ECU (smart key ECU assembly) confirmed the back door lock & close signal.
      Result
      Result Proceed to
      Not output A
      "Back Door Lock & Close signal" is output B

    B

    GO TO POWER BACK DOOR SYSTEM Click here

    A

  2. CHECK ENTRY BACK DOOR OPEN FUNCTION


    1. While carrying the electrical key transmitter sub-assembly, check that the entry unlock function operates when the back door opener switch is operated.

      Click here

      Result
      Result Proceed to
      Entry back door open function operates A
      Entry back door open function does not operate B

    A

    GO TO POWER BACK DOOR SYSTEM (Ciose & Lock Function does not Operate) Click here

    B

    GO TO ENTRY AND START SYSTEM (Back Door Entry Lock and Unlock Functions do not Operate) Click here