REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR TRIM COVER LH

    Click here

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  8. REMOVE REAR DOOR ARMREST SET BRACKET LH

    Click here

  9. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  10. REMOVE REAR DOOR GLASS RUN LH

    Click here

  11. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

    Click here

  12. REMOVE REAR DOOR REAR GUIDE SEAL LH

    Click here

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  14. REMOVE REAR DOOR LOCK ASSEMBLY LH


    1. Disconnect the connector.

      B0059THC01
      *A w/o Double Locking System *B w/ Double Locking System
      *1 Release Plate - -
      B0057OP Downward - -

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Slide the rear door lock assembly LH downward, and pull the release plate out of the rear door outside handle frame sub-assembly LH.

  15. REMOVE DOOR LOCK WIRING HARNESS SEAL


    1. B0059L2C01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Remove the door lock wiring harness seal from the rear door lock assembly LH.

  16. REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY LH

    B0057BZ

    1. Detach the 2 claws.

    2. Using a screwdriver, detach the 2 guides and remove the rear door lock cover sub-assembly LH from the rear door lock assembly LH.

  17. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH


    1. B005A2W

      w/o Double Locking System:


      1. Detach the clamp and remove the rear door lock remote control cable assembly LH from the rear door lock assembly LH.

    2. B0059B9

      w/ Double Locking System:


      1. Detach the clamp and remove the rear door lock remote control cable assembly LH from the rear door lock assembly LH.

  18. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH


    1. B0058KM

      w/o Double Locking System:


      1. Detach the clamp and remove the rear door inside locking cable assembly LH from the rear door lock assembly LH.

    2. w/ Double Locking System:


      1. B0058TO

        Using a screwdriver, detach the claw.

      2. Detach the 2 guides and open the cover.

      3. B00592I

        Detach the clamp and remove the rear door inside locking cable assembly LH from the rear door lock assembly LH.