FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR TRIM COVER LH

    Click here

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  9. REMOVE FRONT DOOR ARMREST SET BRACKET LH

    Click here

  10. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  13. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  14. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

    Click here

  15. REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY LH (for Driver Side)

    Click here

  16. REMOVE FRONT DOOR LOCK ASSEMBLY LH


    1. Disconnect the connector.

      B005B8NC02
      *A w/o Double Locking System *B w/ Double Locking System
      *1 Front Door Lock Open Rod LH - -
      B0057OP Downward - -

      1. Using a T30 "TORX" socket wrench, remove the 3 screws.

      2. Slide the front door lock assembly LH downward, and remove the front door lock assembly LH and cables as a unit.

  17. REMOVE DOOR LOCK WIRING HARNESS SEAL


    1. B005AUQC01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Remove the door lock wiring harness seal from the front door lock assembly LH.

  18. REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY LH (w/o Double Locking System)

    B005AXN

    1. Using a screwdriver, detach the 2 claws.

    2. Detach the 2 guides and remove the front door lock cover sub-assembly LH from the front door lock assembly LH.

  19. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH


    1. B0056YN

      w/o Double Locking System:


      1. Detach the clamp and remove the front door lock remote control cable assembly LH from the front door lock assembly LH.

    2. B0057F4

      w/ Double Locking System:


      1. Detach the clamp and remove the front door lock remote control cable assembly LH from the front door lock assembly LH.

  20. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH


    1. B0059EQ

      w/o Double Locking System:


      1. Detach the clamp and remove the front door inside locking cable assembly LH from the front door lock assembly LH.

    2. w/ Double Locking System:


      1. B0059DD

        Using a screwdriver, detach the claw.

      2. Detach the 2 guides and open the cover.

      3. B005BA4

        Detach the clamp and remove the front door inside locking cable assembly LH from the front door lock assembly LH.