BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. Connect the connector.

    2. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      If the removed nut is the same shape as that shown in the illustration, replace it with a new nut of supplied replacement part.

      B0059FL

  2. INSTALL BLIND SPOT MONITOR SENSOR RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. PERFORM BLIND SPOT MONITOR INSTALLATION CONDITION INSPECTION

    Click here

  4. INSTALL REAR BUMPER COVER

    Click here

  5. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

    Click here

  6. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here