BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB8

DTC Code DTC Name
C1AB8 Destination Information Undefined

DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).

  • CAN communication system

  • Main body ECU (multiplex network body ECU)

  • Blind spot monitor sensor LH

  • Blind spot monitor sensor RH

 -

CAUTION / NOTICE / HINT

Note


  • When checking for DTCs, make sure that the blind spot monitor main switch (combination switch assembly) is on.

  • If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

PROCEDURE


  1. CHECK DTC (CAN COMMUNICATION SYSTEM)


    1. Check for CAN communication system DTCs.

      Click here

      Click here

      OK
      CAN communication system DTCs are not output.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO CAN COMMUNICATION SYSTEM Click here

    OK

  2. REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


    1. Replace the main body ECU (multiplex network body ECU).

      for LHD:

      Click here

      for RHD:

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Blind Spot Monitor Master > Clear DTCs
      Body Electrical > Blind Spot Monitor Slave > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.

      Click here


      Body Electrical > Blind Spot Monitor Master > Trouble Codes
      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      Result
      Result Proceed to
      DTC C1AB8 is not output A
      DTC C1AB8 is output from the blind spot monitor sensor LH (master) B
      DTC C1AB8 is output from the blind spot monitor sensor RH (slave) C

    A

    END (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] WAS DEFECTIVE)

    B

    REPLACE BLIND SPOT MONITOR SENSOR LH Click here

    C

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here