PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the spiral with sensor cable sub-assembly.
  • Spiral with sensor cable sub-assembly

  • Rear television camera assembly

CAUTION / NOTICE / HINT

Note


  • When "!" mark is displayed on the multi-display assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Chassis > Parking Assist Camera > Clear DTCs
    2. Check for DTCs.

      Click here


      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      DTC C1626 is not output A
      DTC C1626 is output B

    A
    B
  2. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Replace the spiral with sensor cable sub-assembly with a new or normally functioning one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT
  3. CHECK FOR DTC


    1. Clear the DTCs.

      Click here


      Chassis > Parking Assist Camera > Clear DTCs
    2. Check for DTCs.

      Click here


      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      DTC C1626 is not output A
      DTC C1626 is output B

    A
    B