| DTC Code | DTC Name |
|---|---|
| B15CC | Backup Battery Failure |
DESCRIPTION
This DTC is stored when the telematics transceiver receives a result "Defect", "High Temperature" or "Low Voltage" or cannot receive any signals during the mayday battery self check.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15CC | Backup Battery Failure | Mayday battery malfunction |
|
WIRING DIAGRAM
| *a | Mayday Battery |
| *b | Telematics Transceiver |
CAUTION / NOTICE / HINT
Note
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK.
When replacing the telematics transceiver, make sure to replace it with a new one.
PROCEDURE
CHECK DTC OUTPUT
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY BATTERY)
Disconnect the I40 telematics transceiver connector.
Disconnect the I41 mayday battery connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK MAYDAY BATTERY
Replace the mayday battery with a normal one and check if the same problem occurs again.
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
END (MAYDAY BATTERY IS DEFECTIVE) |
| B |
|
REPLACE TELEMATICS TRANSCEIVER Click here |